OPERATINGINSTRUCTIONSFINISHER 2700Model No. BA-FS27Banner American Products, Inc.abcoffice 800-658-8788 www.abcoffice.com
7. Set the FORWARD/REVERSE switch to the FORWARD position.8. Turn the MOTOR CONTROL ON/OFF switch to the ON position.9. Turn the MOTOR CONTROL knob fa
CAUTION: Heated Rollers are for warm-up only and should be turned off when operating temp- erature is reached to avoid damaging the rollers
Cleaning RollerShoes™:Clean the RollerShoes™ periodically to avoid adhesive build-up. Build-up can inhibit the film from moving overthe shoes smoothl
Laminated item curls Top or bottom film tension Loosen tension on side (topis too high or bottom) that is curling upLaminated item is wrinkled Mandrel
XIII. Warranty & Return Policy...Warranty:Your Finisher 2700 is warranted to be free of defects in material and workmanship for a period of 1 year
Table of ContentsI. Get to Know Your Laminator ... 1-2II. For Your Safety ... 3III
FORWARDREVERSEUpper MandrelUpperSupplyMandrelHolderEmergencyStop ButtonLower MandrelUpper Idler BarSafety ShieldTie BarLowerSupplyMandrelHolderFeed Ta
Roller Pressure AdjustmentTo Open the Rollers: Pull out the pin and turn handle clockwise until it will not turn anyfarther and the pin locks into pla
u Do not connect the laminator to electrical power or attempt to operate it until you have readthese instructions completely. Keep these instructions
u Do not operate the laminator with a damaged power supply cord or plug.u Replace fuses only with same type rated 30A, 240V and 1A, 250V fuses. Conta
Feed Table Installation:Slide the feed table over the front and rear feed table holders. (The feed table weighs about 15 lbs.)Loading Film onto Mandr
Mandrel Tension AdjustmentMandrel tension must be set correctly to ensure good lamination quality. Adjust the tension by turning theknurled knobs at
VI. Thermal Laminating...1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminatingfilm is
Kommentare zu diesen Handbüchern